III-4
[ 2 ]
Removing the Bottom Cover and the Side Cover
(1)
Turn over the machine and remove four screws to remove the bottom cover.
(2)
Unhook the hook of the slot cover and remove the bottom cover bending the rear face of the
bottom cover slightly outward.
Note: Take care not to damage the USB ID switch when removing the bottom cover.
(3)
Tilt the both side covers toward the arrow direction and remove the side covers.
Fig. 3.1-2 Removing the Bottom Cover and the Side Cover
Screws
Bottom cover
USB ID switch
Screws
Bottom cover
Side cover L
Side cover R
Slot cover
Hook
Summary of Contents for PT-9500PC - P-Touch 9500pc B/W Thermal Transfer Printer
