III-6
(2)
Remove all the connectors and the harnesses connected with the main PCB.
(3)
Remove the soldered two points of the lead wire of the eject motor.
Fig. 3.1-5 Removing the Connectors and the Harnesses
(4)
Remove a screw from the main PCB ASSY and remove the main PCB ASSY.
Fig. 3.1-6 Removing the Main PCB ASSY
Half cutter sensor connector
Solder points of eject motor
Full cutter sensor connector
Half cutter motor connector
Full cutter motor connector
Head flexible cable
Roller holder sensor
Tape feed motor connector
AV sensor PCB
connector
Sub PCB
connector
Tape end sensor connector
Sensor PCB harness
Release motor
connector
AV SW sensor connector
Main PCB ASSY
Screw
Summary of Contents for PT-9500PC - P-Touch 9500pc B/W Thermal Transfer Printer
