III-14
[ 10 ]
Disassembling the Front Cover
(1)
Remove two screws and remove the sub PCB ASSY.
(2)
Remove the power supply switch button and the cut feed button securing together on the sub
PCB by pushing them out from the front cover.
Fig. 3.1-20 Disassembling the Front Cover
[ 11 ]
Removing the Eject Unit ASSY, the Half Cutter ASSY, the Half Spacer and the Cutter ASSY
(1)
Remove two screws from the side face of the mechanical unit, and then remove the eject unit
ASSY, the half cutter ASSY, the half spacer and the cutter ASSY.
Warning :
Take care of the handling of the cutter ASSY and half cutter ASSY to avoid
danger.
Fig. 3.1-21 Removing the Eject Unit ASSY, the Half Cutter ASSY, the Half Spacer and the Cutter ASSY
Front cover
Power supply switch button
Sub PCB ASSY
Screws
Cut feed button
Mechanical unit
Cutter ASSY
(Half cutter ASSY)
Half spacer
Screws
Eject unit ASSY
Half cutter ASSY
Summary of Contents for PT-9500PC - P-Touch 9500pc B/W Thermal Transfer Printer
