III-28
(4)
Pass the harness through the long hole of the mainframe and install the head/roller holder
unit fitting the bosses to the holes of the main frame, then secure the unit with two screws.
(5)
Rotate the release double gear to verify the smooth motion of the roller holder.
Fig. 3.1-49 Reassembling the Head/Roller Holder Unit
(6)
Assemble the AV sensor spring on the AV sensor actuator.
(7)
Assemble the AV sensor actuator on the main frame in the position according to the slot
shape of the main frame.
Note: Verify after the assembly whether the AV sensor actuator moves without a hitch.
Fig. 3.1-50 Reassembling the AV Sensor Actuator
Screws
Head/roller holder unit
Main frame
Release double gear
Main frame
AV sensor spring
AV sensor actuator
1
2
Summary of Contents for PT-9500PC - P-Touch 9500pc B/W Thermal Transfer Printer
