III-31
(4)
Secure the full cutter sensorr ASSY with a screw.
(5)
Secure the half cutter sensor ASSY with a screw.
Fig. 3.1-55 Reassembling the Half Cutter Sensor ASSY and Full Cutter Sensor ASSY
(6)
Install the cutter helical gear into the shaft and secure it using the retaining ring of the cutter
helical gear.
(7)
Set the half rock gear tilting the groove of it at 45-degree.
Fig. 3.1-56 Reassembling the Cutter Helical Gear and the Half Rock Gear
Half frame ASSY
Cutter helical gear
Retaining ring
Half rock gear
45-degree
Screw
Half frame ASSY
Screw
Half cutter sensor ASSY
Boss
Full cutter sensor ASSY
Boss
Summary of Contents for PT-9500PC - P-Touch 9500pc B/W Thermal Transfer Printer
