III-32
[ 5 ]
Reassembling the Cutter ASSY, the Half Spacer, the Half Cutter ASSY, and the Eject Unit
ASSY
(1)
Assemble the cutter ASSY engaging the groove of the movable blade with the cutter rock pin
and fit the round hole and the long hole to the two positioning shafts on the frame ASSY.
Warning: Take care of the handling of the cutter ASSY and Half cutter ASSY blades to avoid
danger.
(2)
Fit the round hole and the long hole of the half spacer to the positioning shafts on the frame
ASSY.
(3)
Engage the groove of the half rock gear with the half rock pin of the half cutter ASSY, and fit
the round hole and the long hole to the two positioning shafts on the frame ASSY.
(4)
Engage the cam of the eject unit ASSY cam part with the cutter rock pin, and fit the round
hole and the long hole to the two positioning shafts on the frame ASSY.
(5)
Press and hold the assembling four units mentioned above and secure them with two
screws.
Fig. 3.1-57 Reassembling the Cutter ASSY, the Half Spacer, the Half Cutter ASSY, and the Eject Unit ASSY
Mechanical unit
Positioning shafts
Half spacer
Half cutter ASSY
Eject unit ASSY
Screws
Eject cam
Cam parts
Half rock pin
Groove
Cutter rock pin
Half rock pin
Cutter ASSY
(Full cutter ASSY)
Summary of Contents for PT-9500PC - P-Touch 9500pc B/W Thermal Transfer Printer
