III-44
[ 13 ]
Reassembling the Shield Plate A
(1)
Fit the positioning hole to the positioning boss on the half frame and secure the shield plate A
with a screw while contacting the bended part to the half frame.
Fig. 3.1-75 Reassembling of the Shield Plate A
[ 14 ]
Reassembling the Slot Cover
(1)
Engage the slot cover to the boss of the bottom cover at the angle as shown in the figure
below.
Fig. 3.1-76 Reassembling the Slot Cover
Shield Plate A
Positioning hole
Positioning boss
Half frame
Bended part
Screw
Slot cover
Bottom cover
Bottom cover
Slot cover
Boss
Summary of Contents for PT-9500PC - P-Touch 9500pc B/W Thermal Transfer Printer
