III-45
[ 15 ]
Reassembling the Side Cover and the Bottom Cover
(1)
Hook both of the side covers hooks to the body cover respectively, and insert the cross rib
into the hole of the body cover.
Note: Make sure that the side cover L and side cover R fit with no gap between any other
parts.
(2)
Replace the bottom cover with four screws.
Note: Make sure that the bottom cover fits with no gap between any other parts.
(3)
Close the slot cover.
Fig. 3.1-77 Reassembling the Side Cover and the Bottom Cover
Screws
Screws
Bottom cover
Cross rib
Cross rib
Side cover R
Side cover L
Cross rib
Hole
Hooks
Hooks
Cross rib
Slot cover
Summary of Contents for PT-9500PC - P-Touch 9500pc B/W Thermal Transfer Printer
