IV - 2
4.3
LED CONTROL IN DIFFERENT SITUATIONS AND MEASURE AGAINST ERRORS
The display priority is specified as follows.
- Red LED ON:
Current jobs are not discarded, Recoverable error.
- Red LED blinking (Slowly):
Current jobs are discarded, Recoverable error.
- Red LED blinking (Fast):
Current jobs are discarded, Recoverable error by ON/OFF key of the
power supply.
- Red LED blinking (Fast 2):
Fatal error, Service may be required.
State of LED
Power
supply
(Green)
Error
(Red)
Status
Remarks
LED
ON
-
Receiving standby mode
Blinking
-
Receiving mode
Starts to print when receiving print start command
(FEED key is disabled when transmitting, printing,
and 2 seconds after printing is completed.)
No medium when
receiving
Returns to the receiving mode by cover close after
a medium is mounted, and starts to print when
receiving the print start command. (Receiving
state is continued.)
Blinking
LED
ON
Cover was opened when
receiving.
Returns to the receiving mode when the cover is
closed, and starts to print when receiving the print
start command. (Receiving state is continued.)
No medium when
waiting for receiving
Returns to the receiving standby mode by cover
close after a medium is mounted.
LED
ON
LED
ON
A cover was opened
when waiting for
receiving.
Returns to the receiving standby mode by cover
close.
LED
ON
LED
ON
FEED key was pressed
when an AV tape is
mounted.
Returns to the receiving standby mode after 3
seconds. (Returns immediately if received data
exists.)
No medium when
printing
Starts to print by cover close after a tape is
mounted.
(Note1)
Wrong medium when
printing
Starts to print by cover close after a tape is
mounted.
(Note1)
A cover was opened
when printing.
Starts to print by cover close.
(Note1)
A cover was opened in
printing.
Returns to the receiving standby mode by cover
close after cancel processing.
Tape end
Starts to print by cover close after a tape is
mounted.
(Note1)
LED
ON
Slow
blinking
Communication error
Returns automatically to the receiving standby
mode after 5 seconds.
Summary of Contents for PT-9500PC - P-Touch 9500pc B/W Thermal Transfer Printer
