IV - 4
Red LED blinking (slowly) 0.5sec/0.5sec
No medium when printing:
The red LED blinks slowly if a cassette is not mounted when receiving the print start
command. If the print restart flag is set, printing is restarted by cover close. (Previous data is
cancelled if the next data is being transmitted.)
Wrong medium when printing:
The red LED blinks slowly if a wrong medium is mounted when receiving the print start
command (the medium specification command should be new). If the print restart flag is set,
printing is restarted by cover close. (Previous data is cancelled if the next data is being
transmitted.
A cover was opened when printing:
The red LED blinks slowly if a cover is opened when receiving the print start command.
If the print restart flag is set, printing is restarted by cover close. (Previous data is cancelled if
the next data is being transmitted.)
A cover was opened when printing:
The red LED blinks slowly if a cover is opened when printing. The status is transferred to the
receiving standby mode by cover close if any medium is mounted, and if no medium is
mounted, transferred to no medium when waiting for receiving.
Tape end:
The red LED blinks slowly, when a tape is consumed up while printing. If the print restart flag
is set, printing is restarted by cover close. For the printing motion, see 6.4 Detection of Tape
End. (Previous data is cancelled if the next data is being transmitted.)
Communication error:
The red LED blinks slowly when any receiving error occurred during data communication.
Returns automatically to the receiving standby mode after 5 seconds.
Red LED blinking (fast) 0.25sec/0.25sec
Cutter jam:
The red LED blinks slowly when the recovery is possible even if the cutter is closed, and when
any error occurs due to disabled cutter close operation. Only turning OFF the power supply is
available for recovery. Returns to the printing standby status after the initialization by turning
ON the power supply.
Roller holder error:
The red LED blinks fast when the recovery is possible even if the roller holder is closed, and
when any error occurs due to disabled roller holder close operation. Only turning OFF the
power supply is available for recovery. Returns to the printing standby status after the
initialization by turning ON the power supply.
Red LED blinking (fast) 2 0.15sec/0.15sec
EEPROM error:
The red LED blinks (Fast in the 2nd level speed), when proper write/read to/from the
EEEPROM failed. Only the power supply OFF is enabled.
Head rank error:
The red LED blinks (Fast in the 2nd level speed) when invalid values was read while the head
rank read initialized by power supply ON. Only the power supply OFF is enabled.
Summary of Contents for PT-9500PC - P-Touch 9500pc B/W Thermal Transfer Printer
