S-7200C
6. USING THE G50 OPERATION PANEL (ADVANCED OPERATIONS)
28
6-2. Adjusting the needle up stop position
1
(While pressing the key (1), press the power ON switch.)
“MorG xxx” will appear in orange in the main display (2).
2
Selecting “UpoS xxx”
(Press once)
“xxx” is the setting value for the needle up stop position, and
“0” is the default setting.
3
Needle up stop position setting
•
If you press the key, the setting value will increase
and the needle up stop position will become lower.
•
If you press the key, the setting value will decrease
and the needle up stop position will become higher.
•
The setting range is from –10 to 10.
* A setting value of “10” corresponds to an angle of rotation
of approximately 10
°
for the upper shaft.
4
The setting values will be memorized.
4192M
5
Normal sewing machine operation will then be possible.
4193M
* For details on other adjustment items, refer to the Service Manual.
4191M 2138M 2139M
Becomes higher
Becomes lower
4189M
(Setting value)
Example:
4190M
