11
b
While squeezing the adjustment lever, slide the right
guide plate against the roll to correctly align the left edge
of the material.
a
Adjustment lever
Note
• The material is correctly loaded when there is a gap of
about 2 to 3 mm between the guide plate and the right side
of the roll. After aligning the left edge of the material, adjust
the guide plate.
a
Gap of about 2 to 3 mm
Checking the End of the Material
Make sure that the end of the material is evenly trimmed to
meet all of the following conditions.
a
It must be straight.
b
The left and right edges of the material must be parallel.
If the material does not meet both (
1
and
2
) of the conditions
described above, it may not be fed correctly.
Before feeding the material, be sure to check this.
1
1
Summary of Contents for ScanNCut DX
Page 1: ...Roll Feeder ...
Page 38: ...English Version A ...