background image

5

Brewing kettle BREWFERM

®

 pro

How to use properly :

•  

Unwind the mains cable completely from the bottom.  

 

Connect the appliance only to a grounded (SCHUKO)  

 

AC power socket that has been installed in 

 

accordance with the regulations and has the voltage   

 

as shown on the specification plate. Mains cable and  

 

plug must be dry. 

•   Do not drag the mains cable along sharp edges.  

 

 

Avoid jamming the mains cable, and do not let  

 

 

the cable be suspended. Protect it from heat. 

•   Use only extension cables that are in perfect 

 

condition and designed for a voltage of at least 10 A. 

•   Do not use the appliance or pull the mains cable 

 

immediately if: 

 

-   the appliance or mains cable is damaged 

 

-   the appliance is leaking 

 

-   there is cause for concern that it may be 

 

 

damaged after it fell down or such 

 

Have the appliance repaired in that case. 

•   Put the appliance on an even and solid base, do not   

 

place it on hot surfaces such as stove tops, hot plates  

 

or near open gas flames; it may start to melt. 

•   Do not switch the appliance on when there is no 

 

liquid inside, otherwise the pot or the grid may be    

 

damaged. 

•   Always place the jars on the gridiron (not part of the   

 

delivery) when preserving food. 

•   Pull the plug in the following cases: 

 

-   malfunction during operation 

 

-   before cleaning and maintaining it after use 

•   The appliance gets very heavy when it is filled 

 

entierely. Therefore, it should only be transported    

 

when it is half full. 

•   Do not submerge the appliance in water when you    

 

clean it.

•   We do not assume any liability for damages caused   

 

by misuse, handling errors or unprofessional repair.    

 

Any warranty is excluded in such cases. 

Application

Before first use: 

•  

Clean pot and lid thoroughly before using it the  

 

 

first time. 

•   Fill about 5 litres of water into the preserving boiler    

 

and boil it out. 

Note:

 When first using the new appliance it may give off 

a slight smell because of technical reasons and does not 

give any cause for concern. 

Indications when operating the appliance:

 

•  

Always unwind the mains cable completely. 

•   Make sure that the mains cable does not get into  

 

 

contact with the hot appliance during operation. 

 

Caution! 

When filling in liquids do not exceed a filling  

 

height of 4 cm below the rim of the pot (corresponds   

 

to 23 litres in cooking mode). Then close the lid.  

 

 

Otherwise there is danger of burns during cooking. 

•   Do not connect the appliance to the grounded  

 

 

(SCHUKO) socket before you have filled it up. 

•   Do not switch the appliance on when there is no 

 

liquid inside, otherwise the enamel or the coated  

 

 

grid may get damaged. If you have – despite all 

 

caution - switched the appliance on without any water  

 

inside, wait for the appliance to cool down again, 

 

before filling in the water, otherwise there is a risk of   

 

burns through escaping steam.

•   Let the condensation water drain into the pot when    

 

removing the lid. 

•   Avoid transporting when the appliance is filled 

 

completely as it is very heavy – danger of injury. 

 

Drain the appliance before transporting it or skim  

 

 

some liquid off. 

•   After using the appliance pull the plug from the socket  

 

and let the appliance cool down. 

•   Use the cable retainer and the plug holder -7-  

 

 

underneath to store the cable after use. 

Application

Summary of Contents for BREWFERM pro










Reviews: