BROWER TIMING SYSTEM TCi-System, User Manual

www.browertiming.com

20 

www.browertiming.com

21

Battery Replacement

TCi-Timer:

  Remove the battery cover on the lower back of the unit.  

Install three fresh AAA alkaline batteries.  Replace the battery cover.  

Battery life: 50 hours/40 hours for Smartphone Version

TCi-PhotoGates A & B:

  Remove the set screw from the base of the unit.  

Apply pressure to the front of the unit between the lens and buzzer to slide 

the unit out of its case.  Replace three batteries (AAA).  Place the unit 

back into the case and replace the set screw.  

Battery life: 220 hours

TCi-Smart Start:

  Remove the set screw on the bottom of the unit. Pull 

the bottom cap off and replace three AAA batteries. Replace the bottom 

cap and set screw. Battery life: 50 hours

TC-Display:

  Remove two small screws from the side of the display. Pull 

the end cap out of the metal casing to expose a battery pack. Pull the bat-

tery pack out of the metal casing. Replace three batteries (AA). Slide the 

battery pack back into the metal casing with the batteries facing the back 

side of the Display. Replace the end cap and two small screws.

Battery life: 100 hours

Caring For Your System

The TCi system is water resistant but not waterproof.  The general rule is 

if you can train in the weather conditions, the system can function.  If it 

is raining too hard to train, take the system out of the rain.  If components 

get wet, let them air dry before putting them back into the foam holder.  

If components get really wet, remove batteries until dry. If not using the 

system for an extended period, remove batteries to prevent leakage and 

corrosion.

*Using the Touch Pad with your feet will accelerate wear*

Specifications

Radio:

  Radio transmission distances up to 850 feet can be received in line 

of sight applications.  Distances can be reduced if 

TCi-Timer

 is in close 

proximity to electric motors and computers or 

TCi-Timer

 is close against 

a body.

Frequency: 432.8     

Timing Accuracy:  1/1000 of a second. 

Radio Switch Accuracy:  0.0005 of a second.

Warranty

The BROWER TIMING SYSTEM is backed by a 1 year warranty cover-

ing manufacturing defects.  Service, whether covered by the warranty or 

not can be performed and returned quickly. (Express incoming and return 

shipping charges are not covered by warranty.)  

*Touch-Pads and Tripods wear out with use and are only covered for 60 

days by the warranty.*

When returning a BROWER component, go to 

www.browertiming.com 

and click “Repair”

FCC Regulatory Compliance Information

FCC ID: XVABTS

NOTE:  This equipment has been tested and found to comply with the 

limits for a Class A digital device, pursuant to Part 15 of the FCC Rules.  

These limits are designed to provide reasonable protection against harmful 

interference when the equipment is operated in a commercial environ-

ment.  This equipment generates, uses, and can radiate radio frequency 

energy and, if not installed and used in accordance with the instruction 

manual, may cause harmful interference to radio communications.  Opera-

tion of this equipment in a residential area is likely to cause harmful inter-

ference in which case the user will be required to correct the interference 

at his/her own expense.

CAUTION:

  Any changes or modification not expressly approved by 

Brower Timing Systems could void the user authorization to operate this 

equipment.

TCi-PhotoGate A compliance labeling

This device complies with Part 15 of the FCC Rules:

Operation is subject to the following two conditions:

1.  This device may not cause harmful interference, and 

2.  This device may accept any interference received, including interfer-

ence that many cause undesired operation.

Brower Timing Systems

12660 South Fort Street #102

Draper, Utah 84020 USA

Phone 801-572-5540  Fax 801-572-5941

techsupport@browertiming.com