BROWER TIMING SYSTEM TCi-System, User Manual

www.browertiming.com

4 

www.browertiming.com

5

Manual Start

Press button to manually start, split or finish 

the timer.  (Similar to a stopwatch)  Using 

this function reduces the accuracy of an 

athletes time due to human error.

Split Review

Press 

Split/Scroll

 buttons to review an ath-

lete’s split times.  (Up to 20 splits possible)  

The Split counter will adjust as each split is 

viewed. Splits can be reviewed while a time 

is running. When reviewing splits if a new 

time starts, it will cause the display to jump 

to the current time.

Athlete Memory Review

To review times, press the 

Memory Review

buttons.  Holding down either button will 

engage the high speed scroll.  The sequence 

will adjust accordingly.  The 

Athlete # 

will 

be displayed also. Dashed lines appear in 

memory every time the TCi-Timer has been 

turned on to mark between timing sessions.

TCi-PhotoGate Setup

Set up the 

TCi-PhotoGate

 units as displayed below at the 

START, 

SPLIT

 or 

FINISH

 location.

Turn on 

TCi-PhotoGate A

 by pressing and holding the power button 

for 2 seconds, it will beep then buzz continually, the green LED will 

also flash.

Point 

TCi-PhotoGate B

 in the direction of 

TCi-PhotoGate A

.

Turn on 

TCi-PhotoGate B

 by holding down the 

On/Off

 button 

until the desired power level is selected.*  The blinking green light 

indicates the unit is on.  

TCi-PhotoGate B

 emits an infrared (IR) light 

beam that is detected by

 A

.

Align 

TCi-PhotoGate B

 by directing it toward the 

TCi-PhotoGate A

until it stops beeping.  Center beam alignment by moving 

B

 in and 

out of alignment.  The 

A

 unit will no longer sound when centered.  

To power down 

TCi-PhotoGates A & B

, press and hold the 

On/Off

button for two seconds.  A low tone beep will indicate power off.

Split/Scroll

Memory Review

New

Manual

Start