25
THE TEN COMMANDMENTS OF OPERATION
1. ALWAYS - Read and understand the owners manual before operating this
or any other equipment.
2. ALWAYS – Attach this product to a skid steer that has suitable safety
equipment properly installed .
3. ALWAYS – Operate this equipment with all safety equipment properly
installed on this equipment.
4. ALWAYS – Start the cutting process by inspecting, walking, flagging or
removing all foreign material from job site.
5. ALWAYS – Do NOT allow riders or bystanders within 300 feet of this unit
during operation.
6. ALWAYS – Check all bolts, fasteners, fittings and oil levels before
operating this equipment.
7. NEVER – Allow blades to make contact with rocks, – unit was not designed
for this type of operation.
8. NEVER – Allow an untrained operator to operate this equipment.
9. ALWAYS – Install genuine Brown replacement parts, all other replacement
parts will void warranty.
10. ALWAYS – REMAIN in cab until the blade has stopped rotating and all
skid steer shut down procedures have been completed.
THESE ARE ONLY A FEW OF THE SAFETY PROCEDURES THAT MUST BE
FOLLOWED TO INSURE THE SAFE OPERATION OF THIS EQUIPMENT – MANY
OTHER SAFETY RELATED POINTS ARE STATED THROUGHOUT THIS MANUAL
WARNING:
FAILURE TO FOLLOW THE TEN COMMANDMENTS
CAN AND WILL CAUSE SERIOUS INJURY OR DEATH
IF YOU HAVE ANY SAFETY, MAINTENANCE OR OPERATIONAL QUESTIONS –
PLEASE CALL BROWN MFG. BEFORE USING THIS EQUIPMENT AT 1-800-633-8909
Summary of Contents for HTS-3020 3000
Page 24: ...Maintenance 24 ...
Page 27: ...27 Notes ...
