IntelliGear Plus
TM
Variable Speed Gearmotors and Motors
4 Commissioning
* Before switching on the IntelliGear Plus
unit, check that the elctrical connections
are correct, and that any moving parts
are mechanically guarded.
* For the safety of personnel, the IntelliGear
Plus must not be switched on with any
protective covering removed.
4.1 Starting with the power supply
This connection jumpers the run command so that the
motor or gearmotor starts as soon as input power is
switched on.
The speed is adjusted with the local control knob
(P3 or P4 options) or a remote reference (0-10V or
4-20 mA).
Power-up: the green indicator lamp is lit continuously.
The control terminals SDI1 and SDI2 (size 33) or 11
and 12 (sizes 31 and 32) are linked (unlocking).
4.1.1 Automatic starting
By connecting a jumper between control terminals 8
and 11 (sizes 31 and 32) or 8 and 9 (size 33), the
motor starts running forward. For reverse rotation
connect terminals 9 and 11 (size 31 or 32) or 8 and 10
(size 33).
4.2 Starting with remote volt-free contact
Once it has been switched on, the motor starts in
accordance with the run command given by the closing
of the volt-free contact corresponding to the desired
direction of rotation.
The speed is adjusted with the local control knob
(P3 or P4 options) or a remote reference (0-10V or
4-20 mA).
4.3 Starting with the local run/stop control (PD, P1 or
P2 options)
Once input power has been switched on, the motor
starts after the button corresponding to the desired
direction of rotation has been pressed for one
second.
The speed is only adjusted with the local control knob
or arrow buttons.
4.4 Setting the speed
4.1.1 External reference (R option)
Adjust the speed reference using the desired
reference of either 0-10 V or 4-20 mA
4.2.2 Control knob options (P3) or remote potentiometer
(supplied by customer)
Adjust the speed reference using a control know or
a remote 10 K
Ω
potentiometer.
4.4.3 Internal speed control option (P4 option)
Adjust the speed reference using an internal speed
potentiometer.
Adjust the max. speed or min. speed setting with
independent potentiometers if it is not possible to
reach the desired speed of operation.
18
MCIM15100E • Form 9112E • Printed in USA