B.U.D.S. PROGRAMMING
WARNING
If programming a Learning or Rental key,
make sure to use the proper key type (color)
to avoid possible confusion. Failure to do so
can result in severe injury or death for the
operator.
smr2009-035-003_c
After approximately 10 seconds, the following
window will pop up confirming the new key has
been saved
in the PC computer
.
smr2008-020-008
If programming is complete, write the changes to
the ECM. Refer to
WRITING CHANGES TO ECM
in this subsection.
Adding another Key
Remove the key on D.E.S.S. post.
Install the next key to be programmed on D.E.S.S.
post.
Click on the desired
Add Key
button.
If programming is complete, write the changes to
the ECM. Refer to
WRITING CHANGES TO ECM
in this subsection.
Erasing one Key
Install the key to be erased to the watercraft
D.E.S.S. post.
smr2009-035-005_a
1. Key to be erased
Click on
Erase Key
button at bottom of B.U.D.S.
screen.
smr2009-035-004_a
1. Click on this button
After approximately 10 seconds the following
message will appear.
smr2009-035-007
The key is now erased
in the PC computer
.
If programming is complete, write the changes to
the ECM. Refer to
WRITING CHANGES TO ECM
in this subsection.
Writing Changes to ECM
Save the changes made in B.U.D.S.
into the ECM
as follows.
Briefly press the start/stop button to prevent
ECM communication interruption during the write
process.
Engine must not crank.
18 / 23
2009-3
PREDELIVERY
