FINAL INSPECTION
vbl2008-007-001
RESET TRIP BUTTONS
NOTE:
It can also be done directly on the info-cen-
ter, using the selector button.
Resetting Last Service
1. Click on the RESET SERVICE button to reset
the informations.
vbl2006-007-004
RESET SERVICE BUTTON
After each maintenance service, last service
should be reset to keep a good tracking of the
vehicle service history.
Speedometer Units
The speedometer is factory preset in miles but it
is possible to change it to kilometer reading. Any
unit modification is applied to the speedometer,
odometer and trip meter.
1. Select SETTING tab in B.U.D.S.
2. Select Miles or Kilometers from the CLUSTER
SCALE section.
NOTE:
No data will be lost when changing this set-
ting.
Ending a B.U.D.S. Session
1. Click on FAULT tab and check if there are active
faults.
– If so, service vehicle then clear the faults in
B.U.D.S.
NOTICE
After a problem has been solved, en-
sure to clear the fault(s) in the ECM. This will
properly reset the appropriate counter(s). This
will also records that the problem has been
fixed in the MPEM memory.
2. Click on WRITE DATA button to transfer new
settings and information to the ECM.
vmr2006-012-100_ben
WRITE DATA BUTTON
3. Click on EXIT button to end session.
4. Disconnect all cables and hardware from vehi-
cle.
5. Ensure to reinstall the cap over the vehicle's
communication connector.
ASSEMBLY INSPECTION
Inspect the following parts to make sure that the
vehicle is properly assembled.
1. Handlebar tightness
2. Wheel nut torque
3. Tubes/hoses routing and condition
4. Steering column cotter pin
5. Suspension arm ball joint cotter pins
6. Tie rod end nuts and cotter pins
7. Wheel nuts and cotter pins
8. Complete applicable recall or factory-directed
modification.
FINAL INSPECTION
Vehicle Test Run
1. Ride the vehicle to ensure proper operation of
all systems and components.
12 / 19
2009-5
PREDELIVERY
