7 of 14
ELECTRICAL CONNECTIONS
Remove electrical cover.
Route wiring harnesses from tiller handle
through channel in flywheel cover.
Apply
Electrical Grease
to connector seals, then
connect tiller handle wiring harness to engine
harness.
Arrange connectors in flywheel cover, as shown,
and install electrical cover. Seal unused
SystemCheck
connector with 6-Pin Connector
Seal, P/N 586076 (not included with kit).
Use tie straps to secure harness to throttle body
bracket.
IMPORTANT:
Route and secure all wires to
avoid contact with moving parts.
Use
Evinrude E-TEC
Diagnostics Software to
reprogram Engine Management Module (
EMM
)
for Tiller Model start-in-gear protection.
1. Electrical cover
002421
1. Seal
42079a
1. Trim and tilt harness
2.
SystemCheck
™ connector (Shown with seal)
3. Start/stop harness
005098
1
1
1
2
3
1. Bracket
005115
WARNING
After installation, dealer must use
Evinrude E-TEC
Diagnostics Software to
reprogram Engine Management Module
(
EMM
) to provide start-in-gear protection.
Failure to provide start-in-gear protection
could create a risk of personal injury or
property damage.
1
