77
ELECTRICAL
ELECTRIC STARTER SYSTEM
4
Inspection
Ignition Switch (Remote Models)
Disconnect the ignition switch from remote control
wiring harness.
Check continuity between switch terminals at the
key positions shown:
O
—
O : Continuity
If out of specification, replace the ignition switch.
Starter Button (Tiller Models)
Disconnect the starter button lead wire.
Check continuity between the wiring leads under
the conditions shown:
If out of specification, replace the starter button.
Neutral Switch
Disconnect neutral switch lead wire.
Check continuity between lead wires while operat-
ing the shift lever of remote control.
If out of specification:
•
Check switch position adjustment.
•
Replace neutral switch.
IMPORTANT:
After installing neutral switch,
check for proper function.
Starter Motor Relay
Remove CDI unit.
Pull out relay and relay holder from electric parts
holder, then remove relay holder from starter
Key
Position
Switch Terminals
M
M
B
A
S
C
OFF
O
O
ON
O
O
START
O
O
O
PUSH
O
O
O
Tester probe connection
Continuity
Probe
Other Probe
Starter
button
not
depressed
White/Red
Brown
No
Starter
button
depressed
Yes
1.
Neutral switch
005566
Shift position
Continuity
Neutral
Yes
Forward
No
Reverse
No
1.
CDI unit
005567
1
1