1. Place the body on your lap with front
side up.
2. Grab the neck and insert the
stringholder piece on the bridge by
sliding it into the two pin holes.
3. Make sure you keep the neck end
away from the body while placing the
stringholder to avoid scratches. Double
check that the stringholder sits tightly.
4. Carefully insert the neck into the pocket
on the body.
5. Lay your elbow onto the bridge and
place your right hand on the fretboard
like shown. With the other hand you
push the neck down firmly until the
Snap System clicks in.
6. Tighten the strapholder knob while you
keep slight pressure with your right
hand still on the fretboard to secure the
neck until the strapholder knob is firmly
tightend! (nice and snug)
7. Pull on each string to bring them back
to their original tune and to help them to
stay better in tune.
8. Your guitar should be very closely in
tune! Only minor tuning might be
necessary.
Owners Manual
of the Brunner-Compact Guitar
www.brunner-guitars.com
Assembling
Your guitar is assembled/disassembled under full string tension without detuning the strings first!
It is therefore highly recommended that you assemble/disassemble your guitar just as described below to avoid any
damages!
Please read the instructions carefully!
