Disassembling and storage in the case
1. Put the guitar on your lap and place
your elbow on the top and press your
right hand on the fretboard like shown.
Then loosen the strapholder knob for
about 5mm.
The neck is still supposed to stay
locked even when the strapholder is
loosened. However, always be ready
for the neck to pop off when you start
operating on the strabholder knob!
2. To release the neck connection push on
the strapholder knob. The neck then will
spring up immediately! Hold the neck
down firmly with your right hand while
pushing on the knob in order to let it
come up slowly and securely.
3. Totally release the string tension now
by lifting the neck up and out of the
pocket on the body.
4. Keep the neck end away from the body
to avoid damage while you carefully
pull the string holder off the bridge. Pull
nicely parallel to the bridge like shown.
5. The neck fits into the bottom of the
backpack below the protection layer.
It‘s supposed to go in up side down
with the string looped around like
shown.
6. The neck is then covered with the
protection layer and the body goes on
top with the front side up.
The lit of the backpack is also a neck rest
to lay the guitar on the floor when it is
assembled.
The shoulder straps can be pulled tight
when not in use.
The B-C Backpack has three different
outside compartments for accessories.
