9
©2004,1998 Bruno Independent Living Aids, Inc.®
CRE-2100 NRUL 08-16-2004
INSTALLATION
Preparation for Installation
Refer to the rail/clamp chart (supplied) for the correct rail-to-step nosing position.
Note: The information on the installation drawing is intended as a guide for the
installer. Rail placement may vary according to conditions found at the
installation site.
Rails are numbered on the bottom side near the end of the rail. The number indicates
rail placement on the staircase. Box 1-Rail #1 is the first rail at the bottom of the stairs;
Box 2-Rail #2 is the next rail as you go up the stairs, and so on.
Remove the protective ends on each rail section as needed.
The hardware securing
these ends are the joint bolts. DO NOT DISCARD.
Attach the lower rail end plate and charge bracket to the lower rail section
before
placing the rail on the stairs. See photos below.
Do NOT attach the
upper
end plate or charge bracket at this time.
upper rail
end plate
(do not
attach at
this time)
bottom rail
end plate
