©2009,1996 BRUNO INDEPENDENT LIVING AIDS, INC.®
SRE-1550 02-09-2009
14
INSTALLATION
1. Install the upper bumper bracket to
rail.
2. Before tightening the bracket, check to
make sure that the bumper wires are
not trapped under the bumper bracket
at the lower landing.
3. Tighten the bracket.
1. Position the charger in a suitable
permanent location
where it will not
create a tripping hazard.
2. Route the battery charger wiring
harness along the back side of the rail.
3. Secure this harness to the rail clamps
with wire ties or double-sided tape
(see note to left).
Be sure that this wiring is
mounted
securely to avoid damage.
4. Secure the charger in the chosen loca-
tion (Step 1) by inserting (2) screws
(provided) through the mounting holes
in the charger base.
NOTE: Th
ere are (2) mounting holes
on each side of the charger base.
Choose one of the two on each side.
UPPER BUMPER BRACKET
CONNECTING THE BATTERY
CHARGER AND ROUTING THE
WIRING HARNESS
Choose one
of these (2)
mounting
holes
Choose one
of these (2)
mounting
holes
After routing the wire harness out of sight,
a small piece of double sided foam tape
can be applied to the harness plugs for
attachment under the rail.
Note: If the c
harger plug and wire are
located in a vulnerable location, use of a
plug lock is recommended to prevent acci
-
dental unplugging. Plug locks are available
at hardware and department stores.
