BRUNSWICK INSTALLATION MANUAL
PAGE 11
BLACK WOLF PRO
GULLY SYSTEM ASSEMBLY (FOR
RETURN SYSTEM TABLES ONLY)
NOTE:
If table is equipped with gully returns,
proceed to install in the following manner.
FIGURE ONE
FIGURE ONE
Step #1
: Place the right-hand foot and gully track into position against
side and end base frame members. Be sure the track is properly positioned
entering the receiver box with the end hanger bracket up against the end
slate attach cleat. All side hanger brackets should be up against the slate
framing. Attach gully track, through hanger brackets, using #12 x 1-1/4”
pan head screws and #12 fender washers. Repeat on opposite side for
left-hand foot end gully track.
Step #2
: Place the right-hand head end gully track into position against side
base frame member. Be sure the track is end-to-end with the previously
attached foot end track and all hanger brackets are up against the slate
framing. Attach gully track, through hanger brackets, using #12 x 1-1/4”
pan head screws and #12 fender washers. Repeat on opposite side for
left-hand head end gully track.
Step #3
: Attach triangle rack bracket, one per side of the receiver box (pilot
holes provided), using #8 x 3/4” pan head screws and #8 fender washers.
HEAD END GULLY SECTION
(2 REQUIRED/ L.H & R.H)
FOOT END GULLY SECTION
(2 REQUIRED/ L.H & R.H)
#12 x 1-1/4” PAN HEAD SCREW
#12 FENDER WASHER
