3
TROUBLESHOOTING
USEFUL INFORMATION / MAINTENANCE
1.
HYDROSTIK
Solid H2 storage
SWITCHING FROM AC TO DC SOLAR OR WIND POWER OPTIONS
HYDROLYSER can be powered by using the standard (included) AC to DC power cable (b), or can be
connected to renewable power sources such as solar PV or small wind turbines. Both sources should
Only use
r.
between red for 1 second and off for 3 seconds, but HYDROCORE charging time will be slower.
If the LED status indicator light alternates red for 1 second and off for 1 second, check the water level
of the water tank and waste water tank. Either add water to the water tank or remove water from the
SOLARIS 26
AC cord
DC cable
DC cable
DC cable
The LED status indicator light d
SOLUTION
HYDROLYSER
3. Fully insert the HYDROCORE cartridge into the HYDROLYSER unit by turning it clockwise into the cartridge
OPERATION INSTRUCTIONS
2
STATUS INDICATOR LIGHTS
The ridge is the
water le
v
el
4. While the indicator light is RED, your HYDROCORE cartridge is being filled with hydrogen. The HYDROCORE
cartridge is fully charged when the indicator lights GREEN. When completed, disconnect the HYDROCORE
Note: 1. It will be normal to hear short bursts or puffs during the refilling procedure, due to water being purged from the system
2. It will be normal to hear the sound of air being released when the HYDROCORE is disconnected from the HYDROLYSER.
5. Disconnect the HYDROLYSER from the AC and empty the water tank if you will not use the HYDROLYSER for
more than one week. If more cartridges need to be charged, repeat step 3.
1. Open the water tank cover located at the top of the unit (Fig. A). Carefully add
water
** EXACTLY up to the ridge level inside the water tank as shown below in Fig. B. Close the cover.
WARNING:
Only use de-ionized
Ridge
status indicator light
will switch from
green to red
Green
System Status
on
HYDROCORE cartridge is full
on
HYDROCORE cartridge is being filled
on 1 second, off 1 seconds
Add water or empty waste water tank
on 1 second, off 1 second
Red
connect HYDROCORE
HYDROCORE
HYDROCORE
HYDROLYSER
HYDROLYSER
Brunton Impel
2. Connect the AC-DC adapter to the unit (Fig. C).
Once plugged in to an AC point, the unit’s status indicator light should start to flash green.
AC-DC adapter (b)
Fig. A
Fig. B
Fig. C
Fig. D
Fig. E
HYDROLYSER
HYDROCORE
