Bandit
59
Copyright 6/12
MODEL 200 UC
The relief valve is typically located internally in the control valve. Do not adjust this relief valve above 2500
PSI (172 bar). The relief valve system is a simple spring tension design but small pieces of debris can stick
the valve partially open which weakens the feedwheel power. The relief as well as hydraulic oil, and screen
must be kept clean.
1. VALVE SEAT:
The springs pushes the relief valve ball against it, until pressure builds.
2. POPPIT VALVE:
This ball opens and closes to relieve excess pressure on hydraulic system.
3. RELIEF SPRING:
This spring tensions the amount of pressure required to open the relief valve ball. This spring weakens
and must be checked and/or readjusted every month for best performance.
4. SLOTTED SET SCREW:
Turn clockwise to increase pressure, but do not surpass maximum of the specified PSI (bar).
5. HEX HEAD PLUG:
Remove to access the relief valve.
YOUR BANDIT CHIPPER IS EQUIPPED WITH ONE OF THREE
HYDRAULIC PRESSURE ADJUSTMENT PROCEDURE OPTIONS.
HYDRAULIC SECTION
PROCEDURE 1 FOR MACHINE WITH NO OPTIONS
1
2
3
4
5
Control Valve
Summary of Contents for 200 UC
