www.brutepower.com
10
Attaching the Side Mounted Discharge Deflector
WARNING: To prevent the engine from
starting, disconnect the wire from the
spark plug.
For shipping purposes, the side deflector was not installed.
Locate the side deflector and install as follows.
1. Raise the mulcher cover
(A, Figure 12).
2. Attach the side deflector
(B). Make sure the locking tabs
(C) go through the slots in the side deflector.
3. Lower the mulcher cover
(A, Figure 13).
4. Attach the wire to the spark plug.
Figure 12: Installing the side discharge deflector
Figure 13: Releasing the mulcher cover
A
B
A
C
Assembly
Attaching the Mulching Plate
(BTPD22625, BTPD22675 Only)
WARNING: To prevent the engine from
starting, disconnect the wire from the
spark plug.
1. Raise the chute deflector
(A, Figure 11).
2. Align the mulcher plate
(B) with the side discharge
opening. Make sure that the two alignment bumps
(C)
are inside the opening.
3. Mount the tab
(D) on the top of the mulcher plate to the
inside of the mower housing.
4. Mount the tab
(E) on the bottom of the mulcher plate to
the inside of the mower housing.
5. Lower the chute deflector.
6. Attach the wire to the spark plug.
Note: On some models, the mulcher kit is installed at the factory.
To convert from a mulcher to a side discharge, simply remove the
mulching plate.
Figure 11: Installing the mulcher plate
(BTPD22625, BTPD22675 only)
D
A
C
E
B
Not
for
Reproduction
