26
Specification
Install Heart Rate Belt (Optional)
OPEN
Strap
Electrodes
NOTE:
x
In cold weather, wear appropriate clothing to keep the heart rate belt warm.
x
The belt should be worn directly on your body.
x
Adjust the sensor position to the middle part of the body (wear it slightly below the chest). The
Bryton logo shown on the sensor should be facing upward. Tighten the elastic belt firmly so that
it will turn loose during the exercise.
x
If the sensor cannot be detected or the reading is abnormal, please warm up for about 5
minutes.
x
If the heart rate belt is not used for a period of time, remove the sensor from the heart rate belt.
NOTE:
Improper battery replacement may cause an explosion. When replacing a new battery,
use only the original battery or a similar type of battery specified by the manufacturer. Disposal of
the used batteries must be carried out in accordance to the regulations of your local authority.
For better environmental protection, waste batteries should be collected separately
for recycling or special disposal.
Summary of Contents for Rider 15
Page 1: ...User s Manual...
