BSD BSD-1000, Operation And Maintenance Manual

BSD-1200 Series 

Maintenance and Inspection: 

1.  The screw driver must be operated in top condition. one day working hour must be not 

more than eight hours.     

2. Periodically check for wear of motor carbon brush, one day for eight hours use is 

normal, replace it after every five to six months.   

3.  Please note don’t let the motor get over heated, every minute use 10~15 screws to 

operate.   

4.  The frequency use of this electric screw driver is over than eight hours a day, still it 

needs periodically testing and treatment. Every 5-6 months. 

5.  Inspect tool cords periodically and if damaged, have them repaired by an authorized 

service facility. Inspect extension cords periodically and replace if damaged. 

6.  Do not remove any labels. Replace any damaged label. 

1.  The use of other than genuine KILEWS replacement parts may Result in decreased 

tool performance and increased maintenance, and may invalidate all warranties.   

2.  All repairs and maintenance of this tool and its word must be performed by an 

authorized service center. 

3.  KILEWS is not responsible for customer modification of tools for applications on which 

KILEWS was not consulted. 

4.  Repairs should by made only by authorized, trained personnel. Consult your nearest 

KILEWS authorized service center. 

5.  It is the responsibility of the employer to place the information in this manual into the 

hands of the operator. 

DO NOT ATTEMPT TO REPAIR THIS   

ELECTRIC SCREW DRIVER 

SAVE THESE INSTRUCTIONS 

DO NOT DESTROY 

7. Servicing 

CAUTION 

CAUTION