15/25
B: Blades are in front of the wind turbine with a Blades protection plate. please make sure the
concave surface of the blades is outside(or face to you).
C: Fix the blades according to the screw holes on it and the screw holes on the steel plate on
wind turbine. Then tighten the Bolt M8x40 through the Blades protection plate and blades. The
screw should be turn into the steel plate of the wind generator only 6mm. please pay high
attention to this operation, otherwise, the wire coil will be destroyed by the bolts.
How bring the blades in Balance, so that the screws are only fixed with a small
torque.
If the system is including the spinner is in balance, please fix all screws with a torque of 22 Nm.
D: Assembling the spinner
Place the spinner on the blades protection plate, thread the
Spinner screw M8x45
into the
screw hole on the blades protection plate and tighten by hex key.
NOTE: so that you still can move the blades, then bring the blades in to the right position.
Please make sure adjusted the 3 blades in balance position.
When you got the balance, the blades can stay in at any position.
THIS IS VERY IMPORTANT!
Please add that the balance test, must be done without any wind.
3.3.2 Mounting the blades and adjust balance process:
1: assembly blades with screws and washers. Screws keep slightly.
2: assembly nose cone, and mark the location.
3: unloaded nose cone when adjusted to balance.
4: tight all screws include the screws of blades finally.
NOTE: the relative Position of nose cone and blades is very important, so keep
the consistent relative position after and before the adjust balance.
Figure 8
Please inform in point 2, that is should be dangerous to install the blades in the wind,
because after assembling, the rotor begin to turn and you can’t stop it, so please be sure,
that the rotor is anywhere fixed before the wind turbine is not ready installed.
When the wires to the charger are fixed at the generator, the please bring at the other
