Motor-driven blocking device EasyBlocker
Installation
instruction
108320
2.1.2 Counterpart
The counterpart is assembled in the door leaf. It needs to be assembled in a way that the bolt can extend
to the limit stop without contact. The maximum distance between the cuff plate and the counterpart
amounts to 8 mm. This way, it is guaranteed that the bolt will move far enough into the counterpart.
Assembly steps:
1.
After having installed the blocking device, connect it to the test device (
refer to the
instructions of
the test equipment for the connecting diagram
). After supplying the distribution voltage (e.g. using
an accumulator) the blocking device will open automatically.
2.
Glue the assembly aid (adhesive felt) on the bolt of the blocking device and color it using an ink
pad.
3.
Close the door.
4.
Lock the blocking device using the test device. The bolt will extend. After several locking trials the
bolt will move back since it cannot reach the end position.
5.
Open the door.
6.
On the door leaf you will recognize a color circle which shows the exact position of the counterpart.
7.
Mark the center using a center punch and drill the hole according to the dimensions of the
counterpart. Please find the installation dimensions of the counterpart on the technical data sheet
(also refer to
8.
Assemble the counterpart.
9.
Close the door and perform a functional check using the test device (also refer to
2.1.3 Magnetic contact
When using the magnetic contact install the magnet (8 mm x 30 mm) which is included in the delivery into
the door leaf beside the counterpart. To do so, place a hole of ø 8 mm and a depth of 30 into the door
leaf.
You will find the correct position of the magnet in
illustration 2-2
or determine the position by means of the
attached drilling template for the magnetic contact.
Attention:
On metal doors the magnetic force to switch the reed contacts is significantly reduced.
Please check on site if it is necessary to use magnets of higher retention force.
It is possible to order a special magnet for metal doors under item No. 108320.M.
108320Err_ENG.doc
version 6.0a / 06.04.2016
page 5
