Motor-driven blocking device EasyBlocker
Installation instruction
108320
2.2.4 Switching on several blocking devices
It is possible to switch blocking devices in parallel so that they all close at the same time. The control
output(s) of the BURGLAR ALARM CENTER are only loaded at minimum due to the little input current of
the blocking device (about 3 mA per input).
In order to close the blocking devices one after another it is possible to cascade the blocking devices.
The outputs
„Closed output“
or
„Opened output“
can be used for status display when switching on the
LEDs.
On the battery version the
„Closed output“
and the
„Opened output“
are implemented as impulse outputs.
I.e. the outputs are controlled for 10 seconds after having opened or closed and then they switch off.
If the input signal changes within this output control time, the correlate output will be deactivated
immediately.
A) Parallel switching of several blocking devices
Illustration 2-11
8320AB211en.tif
page 10
version 6.0a / 06.04.2016
108320Err_ENG.doc
