11
Relay function
-
Wire the two cleving 200 in using the Jack – Jack cord
-
Put the two side in the single mode
-
Start the playback on the first CD player
At the end of the track, the player will be enter in the pause mode and go the next track ( in pause mode ). The
playback will be start in the other side.
-
The relay function will be continuing until you must to stop it.
-
In loading the good cd, you can make your prog order.
-
If you save a cue point, the playback will start from this point.
NOTE:
The relay function will operate well only if you plug the two players on the same mixer or on the same power amplifier.
Sleep mode
If you don’t use the player during o moment ( >15mn), the cd player enter in the sleep mode to safe pick up and
motors life. If the CD deck is open, the cd player will close the deck automatically.
Push the Play or cue buttons to stop the sleep mode.
Installing the Unit
1.
Place your unit on a flat surface or mount it in a secure rack mount case.
2.
Be sure the player is mounted in a well ventilated area where it will not be exposed to direct sunlight, high
temperatures, or high humidity.
3.
Try to place the unit as far as possible from TVs and tuners, as the unit may cause undesirable interference.
CAUTION:
The cd player LCD is designed to be clearly visible within the angles shown in Figure 1. Mount the control unit so that
the visual angle is within this range.
Connections :
1.Turn off the POWER switch.
2.Connect the RCA pin cord to the input on your mixer.
ATTENTION:
••
To avoid sever damage to the unit, be sure the power is off when connections to the unit.
