Switches and Levers
© BT Industries AB 180424-040
26
Active mast rear tilt speed control
•
Tilt the fork backward while pressing the tilt lever knob switch.
As long as this switch remains pressed, the fork is slowed
down while being tilted backward. Unless the switch is
pressed, moreover, the backward tilting speed will be lower at
a high lift.
Parking brake lever
When parking, grasp the grip of the lever and fully pull it toward
you.
When releasing the brake push in the release knob check that
the pawl moves away from the sector and then push back the
lever.
While operation the parking brake lever, keep the brake pedal
fully depressed.
WARNING!
• Never hold the lever at other than the grip because a finger
may be pinched.
When releasing the parking brake by holding the lever for
starting on a slope for example, hold the grip at above the pro-
trusion.
• When parking on a slope, apply wheel chocks to the wheels.
• Traveling without releasing the brake will spoil the brake per-
formance.
Tilt steering adjustment
1.
The steering wheel position may be adjusted back and forth
while the tilt steering adjust lever is kept lowered.
2.
Raising the lever at the proper position fixes the steering
wheel at that position.
3.
After the adjustment, try to move the steering wheel back
and forth to see that it is fixed.
CAUTION!
The steering wheel position must be adjusted before starting
the vehicle.
Adjustment during traveling must be avoided.
Pedals
From the right: accelerator pedal, brake pedal and inching pedal.
Note:
Accelerator pedal stays neutral even when control lever is
shifted to forward-reverse, due to accelerator switch.
The vehicle will move only when accelerator pedal is depressed.
1 Lock
2 Release
3 Release Knob
4 Grip
1 Lower
