Handling the BT DPF-II System (Option)
© BT Industries AB 180424-040
36
Walk around inspection
Vehicle uprightness
Does the vehicle lean to one side or the other?
If so, check for a tire puncture or a problem with the undercar-
riage.
Beneath the vehicle
•
Check for any oil or water leakage on the ground or floor
where the vehicle was parked.
•
Check for loose parts or damage. If any unusual condition is
found, have the vehicle inspected at a BT dealer.
Tire inspection
Tire inflation pressure
1.
Use a tire pressure gauge and measure the inflation pres-
sure. Adjust it to the proper level.
-
See the service data section for the proper inflation pres-
sure.
-
Do not raise the pressure beyond the proper level.
2.
After the adjustment, check if air is not leaking from the
valve.
Damage, crack and wear of tires and rims
•
Check the tires for damage and wear, and the rims for bend-
ing. If the tires are damaged, or there is a marked difference
in the wearing of tires between the front and rear or between
the left and right is perceived, or bent rims are found, ask a
BT dealer for inspection.
Hub nut inspection
•
Check the tightness of the hub nuts.
•
Avoid uneven torque and tighten all of the nuts uniformly.
Refer to service data for proper torque.
Lamp inspection (Rear view mirror and turn signal lamp)
Are the filaments intact? Is there any lens damage?
•
Always keep the lenses clean to insure proper forward vision.
