Message Waiting switch
Your Converse 1300 is preset to
work with BT’s 1571 on normal
exchange lines. If your telephone is
connected to a switchboard you
may need to change the switch
setting on the base of the phone.
Try it on setting 1571, then, if it
doesn’t work, try the other
settings.
Typically, position MW1 is for an
ISDX type switch, but if the light
stays on permanently use MW2.
Typically, position MW3 is for an
SX 2000 type switch.
Message waiting
1. If you subscribe to your network’s answering service (e.g.
BT’s 1571) and you have new messages, your
Message
Waiting
indicator will flash.
To access your messages,
either:
2. Lift the handset (or press
or
and dial
.
Or
Press
. Display shows
BT Service
, press
.
Display shows
BT Answer 1571
, press
again
. 1571 will
be dialled in handsfree mode.
Lift the handset or press
to listen to your messages
privately.
Recall
The Recall
button is used to access a range of
switchboard services, for example, to transfer calls and
with some BT Calling Features.
14
Using the phone
IMPORTANT
If you are not using the power
supply provided, you will need to
fit batteries
(page 6)
to use the
message waiting feature.
If your BT Converse 1300 is
connected to a switchboard, this
feature only works with compatible
models.