PS
S5.5
5710
000
Version no
T-code
F-code
Section
C-code
EV100 Handset Operation
230
Service Manual
1997-09-15
4. Function Set-Up Procedures
With the Handset connected, hold down the CONT key and
turn on the key switch. This will place you in the set up mode,
ready or monitor or adjust control function settings.
At this point another function can be monitored/changed by
pushing another function number, or the truck can be placed
in the run mode by holding the ESC key down for one second
or longer. The display will return to either the diagnostics
mode or the BDI display or a blank display (if BDI is not used
and there are no fault codes). The truck can now be operated
with the handset connected or the handset
can
be
Set Up Mode
Action
Display shows
Remarks
Hold down CONT, turn on key
8888
Segment check displayed
Push function number
U 005
Selected function number is displayed
After one second time delay
085
Stored value for the function is displayed
Push CONT
088
Displayed valve will blink
Charge value with adjustment knob
0125
Value changes while blinking
Push STORE
0125
New valve stored and blinking stops
Push ESC
8888
Segment check displayed
Before making any adjustments to the
control you must consult the operating and
maintenance instructions supplied by the
vehicle manufacturer. Failure to follow
proper set up instructions could result in
mis-operation or damage to the control
system.
WARNING
NOTE! The term push, means to depress key for
approximately one second.
Return
Summary of Contents for OE35
Page 2: ...Return ...
Page 10: ... BT Products 8 Table of Contents Return ...
Page 331: ...Return ...
