PS
S1.2
1700
001
OE35
Version no
T-code
F-code
Section
C-code
Drive Motor 36 Volt
84
Service Manual
1997-10-21
Press on the outer race when installing into end heads.
Press against the inner race when installing onto a
shaft.
2. End heads having slip-fit bearings are
normally
retained by a snap ring. Always install new snap
ring(s).
2.7.3. After Assembly
1. The motor should be connected as specified in
Troubleshooting, and tested to the specifications.
2. When testing motors, the voltmeter connections
must be made at the motor terminals.
3. When Changing Brushes
When changing brushes, the commutator must be serviced
as follows:
1. Resurface the commutator by taking only light cuts
each time, 0.005 in. (0.12 mm).
2. If reslotting/undercutting is necessary, the final
operation is to lightly sand the commutator with a fine
sandpaper to remove any burrs left from the
undercutting operation.
Return
Summary of Contents for OE35
Page 2: ...Return ...
Page 10: ... BT Products 8 Table of Contents Return ...
Page 331: ...Return ...
