PS
S7.0
7110
001
OE35
Version no
T-code
F-code
Section
C-code
Mast, 2 Stage
264
Service Manual
1996-10-15
2. Two Stage Mast
2.1. Removal
1. Disconnect battery and remove from unit.
2. The truck will have to be hoisted and blocked about
6 inches off the floor.
3. Attach a hoist to top of platform and raise platform
to loosen lift chains.
4. Remove chain anchor pins, steering wheel chain,
and electrical cable.
Hydraulically raise inner column enough to remove
platform. Lower platform down and out
inner
column. Lower to floor and place out of the way.
5. Attach a hoist to top of mast through both inner and
outer columns.
6. Before disassembling hoses and fittings from
cylinder, make sure cylinder is in lowered position
and thoroughly clean off all outside dirt around
fittings. After disconnecting hose, immediately cap
ports on both cylinder and hose.
7. Disconnect electrical cable from mast.
8. Remove four mast mounting bolts and hoist to
remove mast from unit.
Always make sure unit is on level surface
before work can begin.
WARNING
Return
Summary of Contents for OE35
Page 2: ...Return ...
Page 10: ... BT Products 8 Table of Contents Return ...
Page 331: ...Return ...
