PS
S7.3
7310
000
OE35
Version no
T-code
F-code
Section
C-code
Lift Cylinder, 2 Stage
282
Service Manual
1997-12-15
1. Cylinder Repair
1.1. Removal
1. Park the truck on a level surface and apply the
brake.
2. Fully extend the cylinder to inspect the rod (8) for
gouges or pits. If gouges or pits are detected, then
the cylinder must be removed for repair.
3. Raise the cylinder rod approximately 6 inches.
Block the mast to prevent lowering.
4. Remove cap screw on top of inner column securing
cylinder rod to inner column.
5. Lower cylinder so the chains, hoses, and electric
cables are loose. Disconnect the battery
6. Remove cylinder bar securing cylinder assembly to
bottom of inner column.
7. Remove cylinder assembly from mast and truck.
8. Clean the exterior of the lift cylinder.
When blocking mast columns to prevent
lowering, always block both sides of the
column. Otherwise, the truck could tip over
on its side.
WARNING
Be extremely careful when working with
solvent. Even a small explosion or fire
could cause injury or death.
WARNING
Compressed air used for cleaning MUST
be reduced to less than 30 p.s.i., and then
only with effective
chip-guarding and
personal protective equipment.
WARNING
Return
Summary of Contents for OE35
Page 2: ...Return ...
Page 10: ... BT Products 8 Table of Contents Return ...
Page 331: ...Return ...
