Micro 70 Wire Guidance
PS
S8.0
8200
F-code
Section
C-code
Version no
T-code
001
OE35
© BT Products
301
Service Manual
1997-10-24
6. Operation Information
6.1. Modes of operation.
There are two modes of operation for the N.D.C Micro 70 wire
guided steering system on the BT OE35 order selector.
1. Automatic mode
Used for on-wire guidance of the truck in the guided
aisle. In this mode of operation the truck operator
controls the travel direction and speed as well as lift
and lower. The steering of the truck is controlled by
the Micro 70 system. Additionally, this mode is used
for acquisition of the guide wire.
2. Manual mode
The truck operator controls all functions of the truck.
Automatic guidance is not enabled in the manual
mode. Manual mode is intended for use outside of
the guided aisle only and should never be used
when operating the truck within the guided aisle.
The truck operator chooses the mode of operation
with a push button switch on the operator's console.
Prior to operating the truck it is essential that the
operator become familiar with all switches
and
indicators on the
console. Only trained
and
authorized operators are permitted to operate this
truck.
6.2. Acquiring the guide wire.
1. In steer wheel direction of travel.
a. Drive the truck in manual mode to the beginning of
the selected aisle. Position the truck to enter the
aisle in the steer wheel direction of travel. The center
line of the truck may be to either the left or the right
side of the guide wire. There should be no other
guide wires between the selected aisle and the truck.
b. Position the steer wheel so that the truck will move to
the guide wire.
Return
Summary of Contents for OE35
Page 2: ...Return ...
Page 10: ... BT Products 8 Table of Contents Return ...
Page 331: ...Return ...
