15 – 2
Repair manual
SWE100, 120, 120L, 120S, 140, 140L, 200D
© BT
Tiller arm 4000
Disassembling the tiller arm
T code
Valid from serial no.
Date
Order no.
841×842×843
6061850-
2012-08-30
258946-120
15.2 Disassembling the tiller arm
1.
Remove the inspection cover.
2.
Remove the cover (T).
3.
Unscrew the retaining screws of the yoke (R).
4.
Remove the cable clip (P) by pressing on it with your thumbs and
lifting it up. Remove the clip through the hole in the control console.
Note:
Do not attempt to pry it out with a screwdriver.
5.
Cut off the cable ties of the cable duct on the transistor regulator
side and disconnect cable connectors X5 and X60.
Assemble in reverse order.
15.3 Replacing the gas strut
1.
Remove the cover (T).
2.
Remove the cable clamp mounting screw (W)
3.
Remove the adjusting screw (Q).
4.
Remove the locking mechanism (E) from the locking shaft (C) of
the gas strut
5.
Remove the locking shaft (c) of the gas strut.
6.
Remove the gas strut.
Assemble in reverse order.
Note:
Pay attention during assembly and make sure no cables are pinched.
https://www.besttruckmanuals.com/
