PLEASE NOTE:
If you change the RADIO LINK CHANNEL in the DMP you must also change the Device Channel in the Options
Menu of the Interface Menu. Both MUST be set to the same number or the audio transmitted from your PC will
not be received by the DMP.
■
When you have selected the correct channel number press the Mode Select button again until the display
shows SAVE SETTINGS & EXIT
■
Press either the Tune up or Tune down buttons to save the changes.
3.6 Setting the Display Contrast
■
Switch on the DMP.
■
Press and hold the Mode Select button until SETUP MENU is displayed.
■
Scroll through the Setup menu by pressing the Mode Select button until the display shows
SET DISPLAY CONTRAST.
■
Use the Tune down button to make the Contrast lighter and the Tune up button make it darker.
■
When you have selected the best Contrast setting press the Mode Select button again until the display
shows SAVE SETTINGS & EXIT
■
Press either the Tune up or Tune down buttons to save the changes.
3.7 Setting the Backlight Mode
You can select between:
Off – the LCD is not backlit
On – the LCD is backlit when the DMP is turned on
Auto – the LCD is backlit when you are operating any of the buttons on the DMP but goes off
after approx. 5 seconds
■
Switch on the DMP.
■
Press and hold the Mode Select button until SETUP MENU is displayed.
■
Scroll through the Setup menu by pressing the Mode Select button until the display shows BACKLIGHT
MODE ON (or OFF or AUTO).
■
Use the Tune down button to select On, Off or Auto.
■
Press the Mode Select button again until the display shows SAVE SETTINGS & EXIT
■
Press either the Tune up or Tune down buttons to save the changes.