TVCC
8
Adjustment and installation of pan & tilt motor
●
Adjust the opening of the cams to the angle
wished, by forcing them slightly.
- Adjust the pan & tilt motor movement here.
Installing the camera case on the pan & tilt motor - item
No. 391803
●
Install the case using the adapter (Fig. 1 and 2).
●
Install the adapter and the case on the pan & tilt motor (Fig. 1,
2 and 4) using the screws as shown in the drawing.
Installing the pan & tilt motor on the bracket - item
No. 391806 (Fig. 3, 4 and 5)
●
Connect the camera-holder support, supplied to the pan & tilt
motor with the two screws (Fig. 3 and 4).
●
Connect the pan & tilt motor to the bracket with the four screws
supplied (Fig. 3 and 5).
Note:
The motor can be installed on the wall or on a pole.
If the bracket is installed on a pole use the pole collar (item
No. 391807).
Caution
Do not position the pan & tilt motor manually, since this
operation may seriously damage the gears.
●
Unscrew the screws and open the pan & tilt motor cover.
●
When adjusting the cams be careful not to damage the compo-
nents.
4
Cam shaft for
vertical movement
Cam shaft for
horizontal movement
