BTM Scandinavia AB
●
Franska vägen 32
●
S-393 56 KALMAR
●
Tel: +46 480 868 75
GENERAL WARNINGS AND INFORMATION SECURITY.
NOTE! Unintentional operation or a damaged controller can lead to serious injuries.
NOTE! Always keep your hands away from the work area.
NOTE! Always follow instructions and procedures accurately and disconnect the unit
from the power source, before inspecting or servicing the equipment.
NOTE! Beware of moving parts.
NOTE! Do not use the machine standing in water or in wet environment.
Spare parts: Use only original BTM components to this system.
Warning messages: If the safety signs or warning signs on the machine are worn or
damaged, ensure exchange before using the equipment.
Personal Protective Equipment (PPE):
No special personal protection equipment is required to operate the machine.
2.2.3 General
Never attempt to join something other than what your tools are specified for.
Never try to make a Clinch through another Clinch or by a spot weld, rivet, or other
obstacles. This will damage the tools.
Never try to make a Clinch more than once. This will damage the tools. If there are any
doubts about joint design, always remove the work and inspect.
Never try to make a Clinch of stainless steel. This will damage the tools
Summary of Contents for ULBG 452-18
Page 28: ...S 7 ...
