Btracking BT-1200 Installation Manual
BEFORE INSTALLING
Prior to the installation process, thoroughly review and adhere to the following
items.
Use only a Digital or Analog Volt Meter - DO NOT USE TEST LIGHT!
Check for possible installation locations for the GPS unit prior to permanent installation.
ALWAYS LOOK BEFORE DRILLING. Make sure that the installation process does not cause damage to any
vehicle hose, electrical loom, or to any part of the vehicle.
Make note of the unit serial number prior to installation.
Prior to working on any part of the dashboard (instrument cluster, center console, glove box, etc.), remove
the negative and positive terminal from the battery to deactivate the sensors for the airbags. Refer to the
Owner’s Manual and to a Shop Manual for the vehicle for specific instructions in the temporary
deactivation process.
DO NOT place objects, including communication equipment, in the area over the airbag or near the airbag
deployment area.
Refer to the Owners Manual and to a Shop Manual of the vehicle for specific information related to the
electrical wiring, interior disassembly, and any other mechanical aspects of the vehicle.
TOOLS NEEDED FOR INSTALLATION
Metric and standard socket set
Screwdriver set
Side cutters, wire cutters
Wire strippers
Pliers
Terminal crimpers
Digital Multimeter
Electrical tape
Flashlight
Warning: It is highly recommended that a Digital Multimeter be used when probing electrical systems in the
vehicle to prevent damage to factory components.
