Operation
- 3-4 -
ULTRAFEEDER
3) Exclusion and Re-inclusion of an ULTRAFEEDER Device
When needed, it is possible to temporarily exclude an ULTRAFEEDER device, in
order to avoid undesired starts due to vibrations, etc. To exclude and re-include a
device, operate as follows:
Exclusion:
Press and hold down for 3 seconds
:
The display will show the exclusion confirmation request.
to confirm the exclusion.
to cancel the operation.
The <<OFF>> indication, shown on display indicates that the device
is currently excluded.
Re-inclusion:
To re-activate the device press and hold down for 3 seconds
.
to confirm the re-inclusion.
to cancel the operation.
In order to temporarily de-activate an ULTRAFEEDER device, simply press
. The condition of device temporarily de-activated is signaled by the
lighting of the two red LEDs on the device, by the lighting of the red LEDs on
the three device’s buttons and by the lighting of the Stop Led on KTF/PW4
device.
4) Control of Temperature and Current Absorbed by ULTRAFEEDER
At any time, pressing the
,
button, you can check the internal temperature (T)
of the control board (42°C in the example below) and of the motor (36°C in the
example below), as well as the current absorbed by the motor (C) in Ampere (0.3 A
in the example below).
Summary of Contents for ULTRAFEEDER
Page 1: ...ULTRAFEEDER YARN CONTROL SYSTEM Operating Manual ENGLISH Rev 4 1 February 2017 ...
Page 40: ...Technical Data and Installation 2 28 ULTRAFEEDER Page intentionally left blank ...
Page 72: ...ULTRAFEEDER Troubleshooting and Maintenance 4 6 ULTRAFEEDER Page intentionally left blank ...
Page 78: ...YTT Device 5 6 ULTRAFEEDER Page intentionally left blank ...
