Operation
ULTRAFEEDER
- 3-13 -
(Example: during the processing phase of wrist band elastic or socks strap, this
function allows performing a yarn tension relaxation at the end of the processing
phase itself, thus permitting an easy clipping operation).
Example of programmed tensions:
MAIN TENSION
(P1) =
2 grams
EXIT TENSION
(P2) =
4 grams
RELAX YARN
(P2) =
0.8 revs of the wheel at the speed defined in P2.3
Choose the desired value using:
(to increase the value)
or
(to decrease the value).
to confirm.
P2.3 = A (Advanced):
The parameter 2.2 indicates the tension, the ULTRAFEEDER shall operate with
when the motor speed is lower than the speed indicated on parameter 2.3.
[Allowed values 0.1 ÷ 95.5 gr].
MAIN TENSION
(P1) =
2 grams
RELAX YARN
(P2) =
0.8 gr when the device speed is < the speed defined on
P2.3
Choose the desired value using:
(to increase the value)
or
(to decrease the value).
to confirm.
P2.3
RELAX SPEED
Yarn feeding speed used to activate the
RELAX YARN
function. When the yarn
feeding speed becomes lower than the value set with this parameter, the
RELAX
TENSION
function will be automatically activated.
3 different settings for the parameter 2.3 are available. Keep the
button
pressed for 3 seconds to switch from a setting to the other.
P2.3 = 0 (OFF)
:
Function disabled
P2.3 = S (Standard):
[Allowed values 00 ÷ 10]
where:
00
means activation speed < 1 mt/min
01
means activation speed 1 mt/min.
02
means activation speed 5 mt/min.
03
means activation speed 10 mt/min.
04 means activation speed 15 mt/min.
.
.
09 means activation speed 45 mt/min.
10 means activation speed 50 mt/min.
Summary of Contents for ULTRAFEEDER
Page 1: ...ULTRAFEEDER YARN CONTROL SYSTEM Operating Manual ENGLISH Rev 4 1 February 2017 ...
Page 40: ...Technical Data and Installation 2 28 ULTRAFEEDER Page intentionally left blank ...
Page 72: ...ULTRAFEEDER Troubleshooting and Maintenance 4 6 ULTRAFEEDER Page intentionally left blank ...
Page 78: ...YTT Device 5 6 ULTRAFEEDER Page intentionally left blank ...
